wince中怎样通过串口下载映像

[lilyhll]

我想在pb中通过串口下载ce的映像,但是怎么下都不成功,文档中说ce中需要通过目标设备上的com2下载映像,目标设备上的com1用于显示调试信息,但是我装pb中机器上只有com1,将pb上的com1和目标机上的com2相连,不能下载,请问该怎样配置,

[songtitan]

1 目标机上需要2个COM,COM1是作为默认调试输出信息的,COM2(or more)用来下载.
2 你要看调试输出:主机COM--COM1,你只要下载:主机COM--COM2;具体配置方法参考MSDN:


You can use a serial port connection to download or debug a run-time image.

For target devices that do not have an Ethernet connection, download and debug using multiple serial ports. To download through a serial port, a serial boot loader is required. A serial boot loader (Sboot.bin) is provided on the x86 boot floppy disk. For more information about boot loaders, see Boot Loaders.

To configure a serial remote connection

Start the target device.
Connect a null modem cable from the development workstation to the COM2 serial port on the target device.
For information on the null modem cable, see Null Modem Cable Architecture.

From the Target menu, choose Connectivity Options to open the Target Device Connectivity Options window.
Below Service Configuration, select Kernel Service Map; then, from the Download list, choose Serial and then choose the Settings button.
The following table shows the settings to use in the Serial Download Settings window.

Field Setting
Port COM2
Baud Rate 115200
Data Bits 8
Parity None
Flow Control None
Stop Bits 1

To complete the remote connection configuration process and close the dialog box, choose OK twice.

[soarstar]

尽量还是用别的方法吧，USB和以太网都可以试试
串口是在太慢了，下载内核速度根本就不能忍受